Showing posts with label hardware. Show all posts
Showing posts with label hardware. Show all posts

Thursday, May 30, 2013

Door Hardware

 The original door hardware was present throughout much of the house when we moved in. We were missing a few doors worth though because the home was expanded over time. It had layers of old paint and was really in bad shape. The original finish was a copper plated brass but most of the copper was gone. After searching everywhere - ebay, old restoration sites, local salvage yards, etc. - we could not find matching hardware. We wanted the house to have a uniform look throughout so we decided to mold the plates and knobs we had and reproduce them. We have removed all the hardware and cleaned it up a few years ago so we had nice pieces to work with.
 The molds were created. A thin layer of vaseline was put on our existing hardware.
 Then the mold was made using Durham's rock hard cement. Then the bondo was poured and allowed to set. The pieces that resulted needed a little trimming/finishing but were a good replica.
 For the door knobs, we used old brass knobs and then just added the pattern to the face.
Once they were completed, the were sprayed with an antique copper paint - the closest to the original color we could find. We still need to install the knobs to all the doors but at least now there is a matching pattern to go throughout the house.

Tuesday, March 5, 2013

New Hinges on the Laundry Room Door

I don't know what someone was thinking when they originally installed the door to the laundry room. The hinge mortice was just taken out of the door and the hinge was sitting flush in the door jam? It also looks like the mortice was chewed out by a beaver. These are the projects that we spend a couple of hours on and when you are done everything almost looks the same. Here is a picture of what the original mortice looked like on the door (not very good looking).

Here is what the door jam looked like (nothing was cut out).
After the old mortice area was chiseled out.

It is a little hard to see in this picture but there is a new piece of wood that is glued into the hole cut out where hinge mortice needs to go. There is another board holding it in place while the glue dries.
The new board is sanded flush with the door and the new mortice is cut.
The door was then planed to get a perfect fit (it used to be a little tight). You can see where the deadbolt on the original door was filled in.
Here is the finished hinge in place in the door jam. Looks much better. Still need to take a picture of the door hung.